Sophivorus (talk | contribs) m (Text replacement - "contact-appropedia-user" to "authors") |
(removed/adapted "This is an appropriate utensil that gives the developing world the opportunity to no longer eat with their hands. This will stop the spread of disease. ") |
||
Line 2: | Line 2: | ||
|title=Spoon Fork Knife | |title=Spoon Fork Knife | ||
|image=Spoon_Fork_Knife_1.jpg | |image=Spoon_Fork_Knife_1.jpg | ||
|description=This OSAT is a Spoon Fork and Knife Combo. This is an | |description=This OSAT is a Spoon Fork and Knife Combo. This is an open source utensil design. | ||
|keywords=3D printing, spork, knife, camping, eating utensil | |keywords=3D printing, spork, knife, camping, eating utensil | ||
|intended-use=cooking, development, hobbyism | |intended-use=cooking, development, hobbyism | ||
Line 32: | Line 32: | ||
==Abstract== | ==Abstract== | ||
# This OSAT is a Spoon Fork and Knife Combo | # This OSAT is a Spoon Fork and Knife Combo. | ||
# A Completed Spoon Fork Knife can be seen on the right [[Image:Spoon_Fork_Knife_1.jpg|400px|right]] | # A Completed Spoon Fork Knife can be seen on the right [[Image:Spoon_Fork_Knife_1.jpg|400px|right]] | ||
# Thingiverse Link http://www.thingiverse.com/thing:1184790/#files | # Thingiverse Link http://www.thingiverse.com/thing:1184790/#files |
Revision as of 23:03, 19 October 2020
Spoon Fork Knife
Created by Austin Ketterhagen Template:Status Template:Status Template:Status
Abstract
- This OSAT is a Spoon Fork and Knife Combo.
- A Completed Spoon Fork Knife can be seen on the right
- Thingiverse Link http://www.thingiverse.com/thing:1184790/#files
Bill of Materials
CAD Files
- See Thingiverse Page
STL
Extra Parts
- There are not other parts needed for this tool.
Tools needed for fabrication of the OSAT
- MOST Delta RepRap or similar RepRap 3-D printer
Skills and Knowledge Necessary to Make the OSAT
- There is no special skills needed to make this tool.
Technical Specifications and Assembly Instructions
- If any changes to the design want to be done, open the FreeCAD file and adjust the parameters.
- Slicing instructions
- Fill % = 100
- Speed = 70 mm/sec
- Layer Height = .10 mm
- Support Needed for Spoon
- Print time with above settings will be 45 minutes
- There is no assembly time
Common Problems and Solutions
Removing build support from spoon side can be difficult. I suggest sanding it smooth after build support removal.
Cost savings
Cost of creating this Spoon
*Filament needed: 5.9 g *At a cost of $22 a kilogram the total cost is $0.13
Commercial Equivalents
*$7.19 ([1])
Saving amount
*The savings are $7.06 *The percentage of the cost savings is 98.2%