Sophivorus (talk | contribs) m (Text replacement - "{{[Ss]tatusboxtop}} ([^@]*?) {{[Bb]oxbottom}}" to "$1") |
No edit summary |
||
Line 10: | Line 10: | ||
|countries-of-design=United States | |countries-of-design=United States | ||
|main-materials=Plastic | |main-materials=Plastic | ||
|estimated-cost-amount=0.13 | |||
|estimated-cost-currency=USD $ | |||
|sustainable-development-goal=SDG03 Good health and well-being | |sustainable-development-goal=SDG03 Good health and well-being | ||
|contact-affiliation=MOST | |contact-affiliation=MOST |
Revision as of 17:59, 15 October 2020
Spoon Fork Knife
Created by Austin Ketterhagen Template:Status Template:Status Template:Status
Abstract
- This OSAT is a Spoon Fork and Knife Combo. This is an appropriate utensil that gives the developing world the opportunity to no longer eat with their hands. This will stop the spread of disease.
- A Completed Spoon Fork Knife can be seen on the right
- Thingiverse Link http://www.thingiverse.com/thing:1184790/#files
Bill of Materials
CAD Files
- See Thingiverse Page
STL
Extra Parts
- There are not other parts needed for this tool.
Tools needed for fabrication of the OSAT
- MOST Delta RepRap or similar RepRap 3-D printer
Skills and Knowledge Necessary to Make the OSAT
- There is no special skills needed to make this tool.
Technical Specifications and Assembly Instructions
- If any changes to the design want to be done, open the FreeCAD file and adjust the parameters.
- Slicing instructions
- Fill % = 100
- Speed = 70 mm/sec
- Layer Height = .10 mm
- Support Needed for Spoon
- Print time with above settings will be 45 minutes
- There is no assembly time
Common Problems and Solutions
Removing build support from spoon side can be difficult. I suggest sanding it smooth after build support removal.
Cost savings
Cost of creating this Spoon
*Filament needed: 5.9 g *At a cost of $22 a kilogram the total cost is $0.13
Commercial Equivalents
*$7.19 ([1])
Saving amount
*The savings are $7.06 *The percentage of the cost savings is 98.2%