| Line 21: | Line 21: | ||
=Bill of Materials= | =Bill of Materials= | ||
* | *control board: MSP430 Launchpad (3.3v only) -$14.01 | ||
*blue tooth-serial port : HC06 -$9.99 | |||
* | *touch sensor: TTP223B -$5.99 | ||
* | |||
=Source Files/ Links= | =Source Files/ Links= | ||
Revision as of 18:39, 11 December 2014
Introduction
This project is setting for RepRap Auto Calibration. Since we need to do a lot of adjustment when we set up the RepRap Printer, the calibration part cost much time and hardly be accuracy. So we build the circuit and program the software to make it automatically, save time, free your hands.
Here is what we need to build this project:
- control board: MSP430 Launchpad (3.3v only)
- blue tooth-serial port : HC06
- touch sensor: TTP223B
Bill of Materials
- control board: MSP430 Launchpad (3.3v only) -$14.01
- blue tooth-serial port : HC06 -$9.99
- touch sensor: TTP223B -$5.99
Source Files/ Links
Tools
- Soldering Iron
- Hobby Knife
- Drill (w/ bits and drive set)
- Allen Wrench Set
- Dremel Tool
- Hammer
- Engineering Prowess
Consumables
- PLA
- Shrink Tube
- Solder
- JB Weld Epoxy