Create the page "Flow rate" on this wiki! See also the search results found.
- Wikipedia:Volumetric flow rate Volumetric Flow Rate Measurement Engineers Edge. (2000). Fluid Volumetric Flow Rate - Fluid Flow. Retrieved October 289 KB (1,474 words) - 19:12, 29 January 2024
- a volume flow of 50% of the design flow rate, one nozzle may simply be capped a fact, which renders excellent dry season performance, when flow available21 KB (3,563 words) - 15:05, 13 September 2024
- where precise volumes of an extrudate need to be delivered at a specific flow rate. In the past decade various open source syringe pump designs have accelerated3 KB (322 words) - 15:58, 23 February 2024
- sediments. The pleats also allow a small increase in flow rate, however an increase in the flow rate can also somewhat decrease sediment removal. These filters6 KB (1,216 words) - 22:47, 18 June 2024
- wheel can be used. The water flow is the rate at which water is moving through the stream at any given moment. The water flow must be consistent throughout13 KB (1,878 words) - 23:48, 13 April 2024
- the normal O2 flow rate nipple that nasal cannulas, NRMs, and BVMs utilize. These CPAP devices come with manufacturer recommended flow rates, often 10 lpm11 KB (1,506 words) - 14:33, 23 October 2023
- for making adjustments. I think changes need to be made to the Feed Rate/Flow Rate and Layer Height. 11/9/2011 - Mounted and testing heated print bed.7 KB (872 words) - 15:38, 9 June 2023
- requires assisted ventilation in addition to supplemental oxygen. The flow rate for a BVM is typically set at 15 LPM. A patient may be ventilated with21 KB (3,005 words) - 15:00, 23 October 2023
- transfer coupled with flow maldistribution for the prototype, however, causes a decrease in the effectiveness at high flow rate, and an increase in effectiveness3 KB (328 words) - 13:10, 23 October 2023
- Pulser pump (section Two Phase Flow)decrease in flow rate expected can be seen below. When the effects of both these variables are combined, the result is a plot showing how the flow rate depends31 KB (5,063 words) - 22:29, 18 June 2024
- achievable for an air-water fluid combination for air-side flow rate of 3-24 L/s and water-side flow rate of 12.5 mL/s. In addition, by fabricating a very thin4 KB (374 words) - 16:00, 23 February 2024
- Solar chimney (section Air Volumetric Flow Rate)in the flow and a friction coefficient of 0.2 the air velocity was determined to be 2 metres per second. As a result, the volumetric flow rate of air leaving12 KB (1,983 words) - 14:50, 28 February 2024
- decreasing flow rate. These results hold for uncorrelated flow maldistribution on both sides or no flow maldistribution on one side. However, when flow maldistribution3 KB (281 words) - 15:57, 23 February 2024
- spring. Must have adequate flow rate. Higher elevation is better(more head). Must be able to measure flow rate. For smaller flows one may contain water using30 KB (4,644 words) - 14:45, 5 September 2024
- the flow rates? What are the initial and annual costs? What are the potential environmental effects of installing micro-hydro? Measuring Flow Rate There40 KB (5,487 words) - 07:04, 9 July 2024
- (kW) Qnet=Flow (Volume/time) - Only take a portion of the max flow (%take). For delicate streams this may be a small percentage of the total flow. Qnet=Qmax*%take9 KB (1,258 words) - 08:15, 29 March 2024
- 1.6 GPM or less low-flow shower heads (section How to determine the flow rate of your current shower head)remove the flow restrictor, which defeats all efforts to conserve water and permits illegal flow rates in the U.S. Flow Restrictor Showerhead flow restrictors21 KB (2,847 words) - 18:43, 8 June 2023
- type Zig Zag Support density 15% Printing temperature 210 C Material flow rate 100% Retraction distance 6.5 mm Retraction speed 25 mm/s Infill speed 505 KB (382 words) - 13:48, 22 May 2023
- height increases, flow rate falls, so at maximum lift, the actual flow rate will be much less than the maximum flow rate. Also, the flow rates are given for17 KB (2,766 words) - 19:13, 29 January 2024
- which attach to the sand particles will clog the filter and reduce flow rate. When flow rate decreases to a level which prevents the necessary amount of water14 KB (1,966 words) - 11:51, 28 February 2024