We continue to develop resources related to the COVID-19 pandemic. See COVID-19 initiatives on Appropedia for more information.

Difference between revisions of "Upgraded Spool Holder"

From Appropedia
Jump to navigation Jump to search
Line 19: Line 19:
  
 
===Printing===
 
===Printing===
The stiffness of the component is driven by the infill percentage. Adjust as necessary to achieve your desired characteristics.
 
  
 
*Print Parameters Utilized
 
*Print Parameters Utilized
**Layer Thickness: 0.2mm
+
**Layer Thickness: 0.20mm
**Skin Thickness: 1.0mm
+
**Shell Thickness: 1.0mm
**Top/Bottom Thickness: 0.5mm
+
**Top/Bottom Thickness: 1.0mm
**Temperature: 180C
+
**Temperature: 210C
**Speed: 80mm/s (60mm/s outer contour)
+
**Speed: 50mm/s
 
**Flow: 100%
 
**Flow: 100%
**Infill: 50%
+
**Infill: 20%
 +
**Filament: [http://pushplastic.com/products/pla-filament?variant=13534677959 Yellow Push Plastic PLA 1.75mm]
  
 
==Installation==
 
==Installation==

Revision as of 04:09, 8 December 2016

MOST Delta filament as guide.JPG This page was part of an MTU course MSE4777 OA and MSE4777 OB/MSE5777/EE4777/EE5777: Open-source 3-D printing

Please leave comments using the discussion tab. The course runs in the Fall semester. It is not open edit.



Upgraded Spool Holder (MOST Delta: Athena)

This upgraded spool holder is made to be fully compatible with the current wire holding mount hardware included with the Athena Printer. The edges are rounded instead of square for better rolling/sliding on the surface. Also the larger size on the upgraded holder is stronger than the original spool holder.

Original Author: Zachary Verran


Ugraded Spool Holder Mounted.jpg

Design and Printing

Design

OpenSCAD was utilized for all modeling operations. Measurements were made to model the mounting bracket already on the printer. Then I designed my upgraded spool holder around this, subtracting the mount from the holder so I knew it would be compatible. The biggest different between the spool holder that is currently utilized on the printer and my upgraded version is the edges of the holder are rounded, making for easier rolling of the spool on the holder. Multiple iterations of trial and error with making the mount stay horizontal with the spool on it were printed, with the final version having a small rectangular protrusion jut out from one side to hold it in place.

The rounded edges of the holder were designed using an OpenScad file found online on Thingiverse. Thank you to user WilliamAAdams for this file. A combination of various sized rectangles based on the Thingiverse file and other primitive volumetric shapes were used to produce the final version.

Ugraded Spool Holder OpenScad.png

Printing

  • Print Parameters Utilized
    • Layer Thickness: 0.20mm
    • Shell Thickness: 1.0mm
    • Top/Bottom Thickness: 1.0mm
    • Temperature: 210C
    • Speed: 50mm/s
    • Flow: 100%
    • Infill: 20%
    • Filament: Yellow Push Plastic PLA 1.75mm

Installation

Delta Dampener Installation
Placement. *Note: You may have to invert the printer to apply enough pressure.  
Fully Installed.  

Link to Files

The file repository is located on Thingiverse

Other Improved Spool Holder Ideas

  1. Put something here

See Also

Open Source 3-D Printing Athena Printer Build Overview MORE Delta Mods]