We continue to develop resources related to the COVID-19 pandemic. See COVID-19 initiatives on Appropedia for more information.

Difference between revisions of "Upgraded Spool Holder"

From Appropedia
Jump to navigation Jump to search
Line 3: Line 3:
 
=Upgraded Spool Holder (MOST Delta: Athena)=
 
=Upgraded Spool Holder (MOST Delta: Athena)=
  
This upgraded spool holder is made to be fully compatible with the current wire holding mount hardware included with the Athena Printer. The edges are rounded instead of square for better rolling/sliding on the surface. Also the larger radius on the upgraded holder is stronger than the original spool holder.
+
This upgraded spool holder is made to be fully compatible with the current wire holding mount hardware included with the Athena Printer. The edges are rounded instead of square for better rolling/sliding on the surface. Also the larger size on the upgraded holder is stronger than the original spool holder.
  
 
Original Author: [[User:ztverran|Zachary Verran]]
 
Original Author: [[User:ztverran|Zachary Verran]]
Line 14: Line 14:
 
OpenSCAD was utilized for all modeling operations.
 
OpenSCAD was utilized for all modeling operations.
  
[[Image:no_image_yet.png|center|400px]]
+
[[Image:Ugraded_Spool_Holder_OpenScad.jpg|center|400px]]
  
 
===Printing===
 
===Printing===

Revision as of 03:52, 8 December 2016

MOST Delta filament as guide.JPG This page was part of an MTU course MSE4777 OA and MSE4777 OB/MSE5777/EE4777/EE5777: Open-source 3-D printing

Please leave comments using the discussion tab. The course runs in the Fall semester. It is not open edit.



Upgraded Spool Holder (MOST Delta: Athena)

This upgraded spool holder is made to be fully compatible with the current wire holding mount hardware included with the Athena Printer. The edges are rounded instead of square for better rolling/sliding on the surface. Also the larger size on the upgraded holder is stronger than the original spool holder.

Original Author: Zachary Verran


Ugraded Spool Holder Mounted.jpg

Design and Printing

Design

OpenSCAD was utilized for all modeling operations.

Printing

The stiffness of the component is driven by the infill percentage. Adjust as necessary to achieve your desired characteristics.

  • Print Parameters Utilized
    • Layer Thickness: 0.2mm
    • Skin Thickness: 1.0mm
    • Top/Bottom Thickness: 0.5mm
    • Temperature: 180C
    • Speed: 80mm/s (60mm/s outer contour)
    • Flow: 100%
    • Infill: 50%

Installation

Delta Dampener Installation
Placement. *Note: You may have to invert the printer to apply enough pressure.  
Fully Installed.  

Link to Files

The file repository is located on Thingiverse

Other Improved Spool Holder Ideas

  1. Put something here

See Also

Open Source 3-D Printing Athena Printer Build Overview MORE Delta Mods]