(Created page with "{{777}} ==Fully adjustable, fully printable filament spool holder== This is a fully adjustable, fully printable spool holder, just as the title says. ==Instructions== These...") |
No edit summary |
||
Line 7: | Line 7: | ||
These parts can be found at [[http://www.thingiverse.com/thing:575388]] | These parts can be found at [[http://www.thingiverse.com/thing:575388]] | ||
====Parts Needed==== | ====Parts Needed==== | ||
In order to create this holder you will need to print off the following parts | In order to create this holder you will need to print off the following parts | ||
The fill of the parts can be fairly low (10%-15%) | The fill of the parts can be fairly low (10%-15%) | ||
Line 20: | Line 23: | ||
# If desired, screw the base to desired location using the tabs on the side of the base. This is not necessary. | # If desired, screw the base to desired location using the tabs on the side of the base. This is not necessary. | ||
#Place the movable part assembly into the base | #Place the movable part assembly into the base | ||
{{gallery | |||
|width=250 | |||
|height=250 | |||
|File:Pin bushing.JPG|step 1 | |||
|File:Pinassem.JPG|step 2 | |||
|File:Fullassembl.JPG|step 4 | |||
}} |
Revision as of 15:12, 9 December 2014
Fully adjustable, fully printable filament spool holder
This is a fully adjustable, fully printable spool holder, just as the title says.
Instructions
These parts can be found at [[1]]
Parts Needed
In order to create this holder you will need to print off the following parts The fill of the parts can be fairly low (10%-15%)
- 1-Base
- 2-Movable parts
- 4-pins
- 4 bushings
part assembly
To Begin
- place the pins into all of the bushings like figure 1 shows
- next place the pin bushing assembly into the moving part as figure 2 shows, depending on your filament the pin may need to be moved into a different spot.
- If desired, screw the base to desired location using the tabs on the side of the base. This is not necessary.
- Place the movable part assembly into the base