Get our free book (in Spanish or English) on rainwater now - To Catch the Rain.

Difference between revisions of "Wire Holder"

From Appropedia
Jump to navigation Jump to search
Line 37: Line 37:
 
|height=135
 
|height=135
 
|title= [[Printable Parts]]
 
|title= [[Printable Parts]]
|Image:cone1.png|Outside Material Funnel Cone
+
|Image:HolderTop.jpg|Wire Holder Top
  
 
|width=180
 
|width=180
 
|height=135
 
|height=135
 
|title= [[Printable Parts]]
 
|title= [[Printable Parts]]
|Image:cone.png|Inside Material Funnel Cone
+
|Image:HolderBottom.jpg|Wire Holder Bottom
  
|width=180
 
|height=135
 
|title= [[Printable Parts]]
 
|Image:ScrewwithHolder.png|Side view Screw with Holder
 
 
|width=180
 
|height=135
 
|title= [[Printable Parts]]
 
|Image:ScrewwithHolder1.png|Top view Screw with Holder
 
 
|width=180
 
|height=135
 
|title= [[Printable Parts]]
 
|Image:T5pulley.png| Main Drive Motor Pulley
 
 
|width=180
 
|height=135
 
|title= [[Printable Parts]]
 
|Image:T5_belt.jpg| T5 Drive Belt
 
 
|width=180
 
|height=135
 
|title= [[Printable Parts]]
 
|Image:Recyclebot auger.png| Recyclebot feeding auger
 
 
}}
 
}}

Revision as of 21:22, 7 November 2016

Wire Holder Prototype

Team

Nicholas Lanter Undergrad student, Computer Engineering

Logan Brueck Undergrad student, Mechanical Engineering

Project

Test Lead Holder

An open source wire lead holder that can be easily printed for any lab. Saving both time and money.

A commercial off the shelf wire holder would cost about $15, this holder will cost $2.07 to print and mount. It can be printed in just a few hours which would be much faster than if you had to order and ship one.

Prototype

Bill Of Materials

  • 3x #6 sheet metal screws @ $0.372 per screw
  • Approximately 70 grams of PLA or equivalent filament @$0.24 per gram. $1.70

Total Cost ~$2.07

Installation and Use

  • Install using 3x #6 sheet metal screws and slide wire holder over screws, then tighten.

Files

Printable Parts
Wire Holder Top  
Wire Holder Bottom