Spoon Fork Knife
Created by Austin Ketterhagen
Abstract
- This OSAT is a Spoon Fork and Knife Combo.
- A Completed Spoon Fork Knife can be seen on the right
- Thingiverse Link http://www.thingiverse.com/thing:1184790/#files
Bill of Materials
CAD Files
- See Thingiverse Page
STL
Extra Parts
- There are not other parts needed for this tool.
Tools needed
- MOST Delta RepRap or similar RepRap 3-D printer
Skills and knowledge needed
- There is no special skills needed to make this tool.
Technical Specifications and Assembly Instructions
- If any changes to the design want to be done, open the FreeCAD file and adjust the parameters.
- Slicing instructions
- Fill % = 100
- Speed = 70 mm/sec
- Layer Height = .10 mm
- Support Needed for Spoon
- Print time with above settings will be 45 minutes
- There is no assembly time
Common Problems and Solutions
Removing build support from spoon side can be difficult. I suggest sanding it smooth after build support removal.
Cost savings
Cost of creating this Spoon
*Filament needed: 5.9 g *At a cost of $22 a kilogram the total cost is $0.13
Commercial Equivalents
*$7.19 ([1])
Saving amount
*The savings are $7.06 *The percentage of the cost savings is 98.2%
Gallery
-
Spoon Fork Knife 1
-
Spoon Fork Knife 2