{"id":65037,"key":"Spoon_Fork_Knife","title":"Spoon Fork Knife","latest":{"id":1102160,"timestamp":"2024-04-16T19:38:09Z"},"content_model":"wikitext","license":{"url":"https://www.appropedia.org/Appropedia:Copyrights","title":"CC-BY-SA-4.0"},"source":"{{777 notice}}\n\n[[File:Spoon Fork Knife 1.jpg|thumb]]\n\n{{Device data\n| manufacturing-files = https://www.thingiverse.com/thing:1184790/#files\n}}\n\n{{Project data\n| authors = User:97.88.41.192\n| made = Yes\n| replicated = No\n| cost = USD 0.13\n}}\n\n== Spoon Fork Knife ==\n\nCreated by [[User:atketter|Austin Ketterhagen]]\n\n== Abstract ==\n\n# This OSAT is a Spoon Fork and Knife Combo.\n# A Completed Spoon Fork Knife can be seen on the right [[Image:Spoon Fork Knife 1.jpg|400px|right]]\n# Thingiverse Link http://www.thingiverse.com/thing:1184790/#files\n\n== Bill of Materials ==\n\nCAD Files\n\n* See Thingiverse Page\n\nSTL\n\n* [[File:Spoon-Fork-Knife.stl|Spoon Fork Knife]]\n\nExtra Parts\n\n* There are not other parts needed for this tool.\n\n== Tools needed ==\n\n# [[Athena Build Overview|MOST Delta RepRap]] or similar RepRap 3-D printer\n\n== Skills and knowledge needed ==\n\n* There is no special skills needed to make this tool.\n\n== Technical Specifications and Assembly Instructions ==\n\n# If any changes to the design want to be done, open the FreeCAD file and adjust the parameters.\n# Slicing instructions\n## Fill % = 100\n## Speed = 70 mm/sec\n## Layer Height = .10 mm\n## Support Needed for Spoon\n# Print time with above settings will be 45 minutes\n# There is no assembly time\n\n=== Common Problems and Solutions ===\n\nRemoving build support from spoon side can be difficult. I suggest sanding it smooth after build support removal.\n\n== Cost savings ==\n\nCost of creating this Spoon\n \t*Filament needed: 5.9 g\n \t*At a cost of $22 a kilogram the total cost is $0.13\nCommercial Equivalents\n \t*$7.19 ([http://www.amazon.com/Light-Fire-Original-Full-Sized-Green/dp/B0024M52LO/ref=sr_1_3?ie=UTF8&qid=1449348029&sr=8-3&keywords=spoon+knife+fork+combo])\nSaving amount\n \t*The savings are $7.06\n \t*The percentage of the cost savings is 98.2%\n\n== Gallery ==\n\n<gallery>\nImage:Spoon_Fork_Knife_1.jpg| Spoon Fork Knife 1\nImage:Spoon_Fork_Knife_2.jpg| Spoon Fork Knife 2\n</gallery>\n\n{{Page data\n| keywords = 3D printing, spork, knife, camping, eating utensil, Plastic\n| sdg = SDG03 Good health and well-being\n| organizations = Michigan_Tech's_Open_Sustainability_Technology_Lab\n| license = CC-BY-SA-3.0\n| language = en\n}}\n\n[[Category:OSAT 3D-Printable Designs]]\n[[Category:Food]]\n[[Category:3D printing]]\n[[Category:Plastic]]"}