The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
This design was created in response to a design request submitted by Field Ready, a non-profit 501c3, that seeks to make field ready humanitarian solutions to problems across the world. The design fulfills the need for a cheap single 3D print that will function as a ECG limb lead holder. The device was designed using dimensions similar to the previous device used as requested.
Requested parameters for the printed part are as follows:
3D printable as a single item (not made up of multiple parts)
Similar Dimensions to original part
Quick, easy, and intuitive to use
Contain an appropriate placed hole such that existing sensors can be attached
Technical Specifications and Assembly Instructions
Printing Instructions:
Print Speed: 100 mm/S
Fill Density: 10%
Layer Height:.20 mm
Support Type: Everywhere
Platform Adhesion Type: Brim (10 lines)
Print time estimate: 55 minutes
There is no necessary assembly
Common Problems and Solutions
Curling of 3D print off of print bed - Due to the thin cross-sectional area it might be necessary to use a brim or skirt to secure the lower layers of the print to your print bed
Cost savings
Estimated Cost ~ $0.35 depending on filament price