Bicycle Brake Caliper

MOST Delta filament as guide.JPG This page was part of an MTU course MSE4777 OA and MSE4777 OB/MSE5777/EE4777/EE5777: Open-source 3-D printing

Please leave comments using the discussion tab. The course runs in the Fall semester. It is not open edit.


Bicycle Brake CaliperEdit

Project developed by Albert Cowsky
Status
This OSAT has been designed but not yet tested - use at own risk.
This OSAT has been prototyped.

You can help Appropedia by contributing to the next step in this OSAT's status.

AbstractEdit

Brake Calipers are an important component required to build a bicycle. In order to build a cheaper, open source, bicycle, the calipers can be printed and fitted with brake pads. Open source bicycles could reduce the cost of transportation for people that cannot afford to buy a commercial bicycle. This project can be combined with others to make a largely cheaper and printable bicycle.

Bill of MaterialsEdit

(Makes Two Calipers)

Files

Commercial Parts

Tools needed for fabrication of the OSATEdit

Skills and Knowledge Necessary to Make the OSATEdit

N/A

Technical Specifications and Assembly InstructionsEdit

(I do not currently have all the necessary materials so they will not all be shown here. I will update this in the future if I get a chance to actually implement it.)

Print time = 3 hours per caliper. 6 hours total

Bicycle Brake Caliper Print.jpg

Assembly time = approximately 15 minutes

Bicycle Brake Caliper Assembled.jpg

  1. Remove parts from the print bed
  2. Attach the base of the calipers to the fork of the bicycle with bolts.
  3. Use a washer on the far side before putting the nut on.
  4. Install brake pads into inward facing cylinders.
  5. Connect the cable guide receiver to the right caliper with a bolt.
  6. Put the cable guide into the receiver.
  7. Run a bolt backwards through the top of the left caliper.
  8. Add a washer and screw the nut most of the way on.
  9. Adjust the brakes so there is only a small clearance (~3mm) between the brake pads and the wheel wall.
  10. Wrap the brake cable around the bolt underneath the washer.
  11. Tighten the nut down to secure the brake cable.


Common Problems and SolutionsEdit

  • Brake line comes loose
    • Ensure that the bolts are still properly tightened every few weeks

Cost savingsEdit

  • Total Cost (two calipers) = $19.60
    • Commercial Component Cost = $17.31
    • Plastic Cost - 99.4g (49.7 each) at $23/kg = $2.29
  • |Commercial Calipers
    • $16-$40 each
    • $32-$40 for two
  • $12.4 - $20.4 savings for two calipers
  • 38.75% - 51% savings

ReferencesEdit

N/A