Jump to navigation Jump to search
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
|Project was made?|
|Project was made independently?|
|Countries of design|
|Estimated cost||USD $ 2.00|
Bicycle part: 7up
|This Open Source Appropriate Technology has been designed but not yet tested — use at your own risk.|
|This Open Source Appropriate Technology has been prototyped.|
- The project was offered from Dr. John Gershenson, part of his lab for measurements.
- Picture of completed print
Bill of Materials
- Only plastics and 3D-printer needed.
Tools needed for fabrication of the OSAT
- MOST Delta RepRap or similar RepRap 3-D printer
Skills and Knowledge Necessary to Make the OSAT
- basic measurement
Technical Specifications and Assembly Instructions
- Print the top part and down part separately.
- Joint them by heater through the edge of each part.
- printing time for each part is about 1.5 hours.
- Jointing time is about 15 min.
Common Problems and Solutions
- Carefully when using the heater, don't burn yourself :)
- If your solution is not a low cost one then it is not really appropriate.
- Estimate your costs: about 2 dollar.
- Find a commercial equivalent: about 10 dollar because of the material.
- 8$ savings and 80% savings