J.M.Pearce (talk | contribs) |
(→BOM) |
||
Line 3: | Line 3: | ||
==BOM== | ==BOM== | ||
* Lulzbot hexagon hotend $70 https://www.lulzbot.com/products/lulzbot-hexagon-hot-end | * Lulzbot hexagon hotend $70 https://www.lulzbot.com/products/lulzbot-hexagon-hot-end | ||
* 24V/4-5A power supply | |||
* 3mm id x 6mm od PTFE tubing 630mm long | |||
* 2x M6 x 0.8mm hex nut | |||
* 3mm print effector | |||
* 3mm extruder drive body | |||
* ~1m 18ga speaker wire | |||
* 2x ~1m 28ga twisted pair | |||
* Heat shrink tubing | |||
==OpenSCAD design== | ==OpenSCAD design== |
Revision as of 11:56, 23 October 2015
BOM
- Lulzbot hexagon hotend $70 https://www.lulzbot.com/products/lulzbot-hexagon-hot-end
- 24V/4-5A power supply
- 3mm id x 6mm od PTFE tubing 630mm long
- 2x M6 x 0.8mm hex nut
- 3mm print effector
- 3mm extruder drive body
- ~1m 18ga speaker wire
- 2x ~1m 28ga twisted pair
- Heat shrink tubing
OpenSCAD design
- OpenSCAD
- STL
Build Instructions
Operating Instructions on a MOST Delta
- Tested with Maxpower 333605 Residential Grade Round .105-Inch Trimmer Line 690-Foot Length from Amazon for $24.35/3 pounds (1.3kg) so $18.73/kg, which is much better than commercial nylon filament that runs up to $100/kg
To print in nylon using weed wacker filament do the following: