Sophivorus (talk | contribs) m (Text replacement - "manifest-autho-email" to "manifest-author-email") |
Sophivorus (talk | contribs) m (Text replacement - "<!--infobox--> <!--end infobox-->" to "") |
||
Line 25: | Line 25: | ||
}} | }} | ||
{{777}} | {{777}} | ||
==Title of the device or system == | ==Title of the device or system == | ||
Handlebar grip for a bicycle developed by [http://www.appropedia.org/User:Ab91 Abhijeet Divekar] | Handlebar grip for a bicycle developed by [http://www.appropedia.org/User:Ab91 Abhijeet Divekar] |
Revision as of 15:59, 23 September 2020
Title of the device or system
Handlebar grip for a bicycle developed by Abhijeet Divekar
Abstract
This part was built to meet the needs of one of our professors; Dr. Greshenson, that heads a bike Enterprise program at Michigan Tech.
Bill of Materials
- No additional materials needed. Open source softwares, computer and RepRap is all you need.
Tools needed for fabrication of the OSAT
- MOST Delta RepRap or similar RepRap 3-D printer
- OpenSCAD
- Slicing Software, like Cura or Slic3r
Skills and Knowledge Necessary to Make the OSAT
- No special skill(s) needed.
Technical Specifications and Assembly Instructions
No special instructions needed. Pretty straight-forward.
Common Problems and Solutions
- Include common mistakes/problems to avoid in building your OSAT and how to overcome them
Cost savings
- If your solution is not a low cost one then it is not really appropriate.
Typical handlebar grip costs anywhere between $3 - $8 Amazon. The 3D printed equivalent costs about 60 cents for a pair. So the cost basically reduced about 10 times the commercial equivalent.
References
- Dr. Greshenson's Lab for measurements.