m (Text replacement - " Project developed by" to "Project developed by")
No edit summary
Line 10: Line 10:
|countries-of-design=United States
|countries-of-design=United States
|main-materials=Plastic
|main-materials=Plastic
|estimated-cost-amount=3.00
|estimated-cost-currency=USD $
|sustainable-development-goal=Sustainable Development Goal 10, SDG03 Good health and well-being, SDG11 Sustainable cities and communities
|sustainable-development-goal=Sustainable Development Goal 10, SDG03 Good health and well-being, SDG11 Sustainable cities and communities
|contact-affiliation=MOST
|contact-affiliation=MOST

Revision as of 12:26, 16 October 2020

FA info icon.svg Angle down icon.svg Device data
Manufacturing files https://www.youmagine.com/designs/toilet-paper-holder-5-18
Hardware license CERN-OHL-S
Certifications Start OSHWA certification

Toilet Paper Holder

Project developed by jdmajors Template:Status Template:Status


Abstract

  1. This is a helpful OSAT project because it will help anyone in the developing world keep any toilet paper off the ground where it could potentially get wet or dirty therefore this is a more sanitary and will waste less toilet paper.
  2. Picture of completed print using your printer
    Holderonbed.jpg

Bill of Materials

  1. Provide a full BOM -- PLA Plastic, (https://www.mcmaster.com/1986k16)compression spring or something similar
    1. Upload and link to all source files from open source CAD (https://www.youmagine.com/designs/toilet-paper-holder-5-18) YouMagine link
    2. Upload and link to all STLs Same as the previous link

Tools needed for fabrication of the OSAT

  1. MOST Delta RepRap or similar RepRap 3-D printer

Skills and Knowledge Necessary to Make the OSAT

  • Basic 3D printer knowledge.

Technical Specifications and Assembly Instructions

  1. Assemble the spring into the larger tube and then insert the smaller tube into the large tube making sure it slides freely but locks in with the small groove on the inside of the large tube. Make sure the two tubes slide freely then and rotate in the holders. Then Place the holders in the desired location Mark screw holes and then attach to the wall.
  2. Print time estimate: 10 Hours
  3. Assembly time estimate: 10 minutes
  4. Including drawings or pictures of the device at stage of assembly at minimum. Toilet Paper Holder


Common Problems and Solutions

  • Common problems: if you don't want to use support material make sure the tubes appear to be upright in the slicer otherwise they will not of as high of quality if they are laid flat.

Cost savings

  1. $1-3 in plastic $1 Spring
  2. Find a commercial equivalent, cite it and put the [1]
  3. Total Savings of about $10 over commercial equivalent.

Benefited Internet Communities

  • Name and add links to at least 5 using single brackets around [url name]

References

  • No references were used.


Based on the developmental needs addressed (e.g. food, heat, electricity, clean water, health care, etc.) be sure to label your device in the proper categories e.g. use [[Category:Water]]. Be sure to categorize your device so that it will be easy to find – for example “Low voltage connection basics” is categorized in [[Category:How tos]] [[Category:health care]] [[Category:cleanliness]] [[Category:house hold]]

Cookies help us deliver our services. By using our services, you agree to our use of cookies.