- untested
- not ergonomic
- upper supports weak
- too much mass in unnecessary locations- bulkiness
- yet not sturdy enough for use
Title of the device or system
Project developed by Ickesler
Template:Statusboxtop Template:Status-design Template:Status-prototype You can help Appropedia by contributing to the next step in this OSAT's status. Template:Boxbottom
Abstract
Snowshoes help to maneuver through a snowy terrain by foot. They allow someone to walk on top of the snow as opposed to sinking down into the snow with every step. This allows for easier movement across powdered snow, without taking a lot of effort to pull your foot out of knee deep snow with every step. This snowshoe design allows someone to print a snowshoe on a 3D printer that utilizes a 1/2" tubing for the outer support, and twine for the straps. All of these supplies are fairly cheap and easy to transport.
Bill of Materials
Printed parts from YouMagine
- Snowshoe Part 1
- Snowshoe Part 2
- Snowshoe Part 3
- Snowshoe Part 4
- Fastener Insert
- Tube Insert
Other Parts:
- 1/2" PVC piping with end covers
- twine or straps
Tools needed for fabrication of the OSAT
- MOST Delta RepRap or similar RepRap 3-D printer
Skills and Knowledge Necessary to Make the OSAT
- 3D Printing
Technical Specifications and Assembly Instructions
- Each of the Snowshoe parts fit together. The parts fit in numberical order.
- The tube inserts go in the slots on the side of the snowshoe.
- The rectangular inserts get pressed into the sqiare holes, securing everything in place.
Print Time Estimates:
- Snowshoe Part 1
- 5 hours 22 minutes
- Snowshoe Part 2
- 6 hours 4 minutes
- Snowshoe Part 3
- 9 hours 55 minutes
- Snowshoe Part 4
- 4 hours 45 minutes
- Tube Insert
- 23 minutes each
- Rectangular Insert
- 5 minutes each
Common Problems and Solutions
- Make sure to remove all support material or the pieces might not fit together.
Cost savings
Printing Cost: $13.34
Commercial equivalent: L.L. Bean Snowshoes $109
Cost Savings: $95.66 (87.76%)