No edit summary |
No edit summary |
||
Line 12: | Line 12: | ||
===Software Setup=== | ===Software Setup=== | ||
Franklin is installed on a Raspberry Pi and connected to the Prusa. The files for Franklin can be found [here: https://github.com/mtu-most/franklin]. How to install Franklin can be found [here: http://www.appropedia.org/Franklin:MOST] | |||
===Loading the pump=== | ===Loading the pump=== |
Revision as of 01:33, 12 June 2016
Template:Statusboxtop Template:Status-design Template:Boxbottom
Purpose
How to Operate
The following directions provide a step by step process for the use of a syringe pump attachment. The focus will be set up of the software, loading the pump, loading the syringe with the ink, zeroing the syringe tip, printing, and moving to idle.
Software Setup
Franklin is installed on a Raspberry Pi and connected to the Prusa. The files for Franklin can be found [here: https://github.com/mtu-most/franklin]. How to install Franklin can be found [here: http://www.appropedia.org/Franklin:MOST]
Loading the pump
Loading the syringe
Zeroing the syringe end
Printing
Setting to idle
Designs
To be added after paper submission