J.M.Pearce (talk | contribs) mNo edit summary |
J.M.Pearce (talk | contribs) mNo edit summary |
||
Line 15: | Line 15: | ||
[[Image:open_source_lens_holder.jpg|thumb|left|Fig 1: Open Source Lens Holder]] | [[Image:open_source_lens_holder.jpg|thumb|left|Fig 1: Open Source Lens Holder]] | ||
[[image:thumb.jpg|thumb|Fig 2: Detail thumb screw]] | |||
The lens holder consists of three components: the metal rod, the plastic base, and the lens holder. The metal rod fits through the lens holder and the lens holder is held in place with a set screw. The lens is placed within the lens holder is held in place with another set screw. Care must be taken when placing the lens within the holder and using the set screw to not damage the optics by overly tightening the set screw. The wide plastic base gives the whole setup stability and flexible placement. | The lens holder consists of three components: the metal rod, the plastic base, and the lens holder. The metal rod fits through the lens holder and the lens holder is held in place with a set screw. The lens is placed within the lens holder is held in place with another set screw. Care must be taken when placing the lens within the holder and using the set screw to not damage the optics by overly tightening the set screw. The wide plastic base gives the whole setup stability and flexible placement. | ||
Line 21: | Line 23: | ||
For full [[3D printing]] details and [[OpenSCAD]] files see: http://www.thingiverse.com/thing:26752 | For full [[3D printing]] details and [[OpenSCAD]] files see: http://www.thingiverse.com/thing:26752 | ||
STl of thumbscrew only at http://www.thingiverse.com/thing:30500 |
Revision as of 17:59, 18 September 2012
Template:Statusboxtop Template:Status-design Template:Status-prototype Template:Status-verified Template:Boxbottom
This project is part of a collection on open source optics meant to radically reduce the cost of experimental optical equipment.
This open source lens holder is designed to hold a 1 inch diameter lens and is comparable but more flexible than commercial optical equipment products such as the Thor Labs Lens Holder here.
The lens holder consists of three components: the metal rod, the plastic base, and the lens holder. The metal rod fits through the lens holder and the lens holder is held in place with a set screw. The lens is placed within the lens holder is held in place with another set screw. Care must be taken when placing the lens within the holder and using the set screw to not damage the optics by overly tightening the set screw. The wide plastic base gives the whole setup stability and flexible placement.
This optical component is not designed to be fitted into an optical breadboard or lab bench. The advantage of this is that there is no limit to placement for the lens holder within the optical system. However, the disadvantage is loss of stability associated with an optical lab bench.
For full 3D printing details and OpenSCAD files see: http://www.thingiverse.com/thing:26752
STl of thumbscrew only at http://www.thingiverse.com/thing:30500