(Created page with "==Method== category:MOST methods") |
J.M.Pearce (talk | contribs) mNo edit summary |
||
(3 intermediate revisions by 2 users not shown) | |||
Line 1: | Line 1: | ||
{{MOST}} | |||
==Method== | ==Method== | ||
To achieve dots in Inkscape: | |||
*Zoom into the grid so that you are pretty close, and the grid's squares are consistent. | |||
*draw a line that is eight squares long (about equal to 1 cm) | |||
*the laser welder's motors move it about this length before turning on the laser, and it turns it on for a very small length, yielding a dot. | |||
'''Warning:''' | |||
-Motors in laser welder are very inconsistent, and sometimes the Inkscape document does not look like the actual welded pattern. | |||
-Needs further investigation. | |||
'''Important Check List:''' | |||
*Do the patterns consistently work? | |||
*Do your patterns match up in welder? | |||
*Do your patterns line up consistently? | |||
[[category:MOST methods]] | [[category:MOST methods]] |
Revision as of 12:18, 10 October 2014
Method
To achieve dots in Inkscape:
- Zoom into the grid so that you are pretty close, and the grid's squares are consistent.
- draw a line that is eight squares long (about equal to 1 cm)
- the laser welder's motors move it about this length before turning on the laser, and it turns it on for a very small length, yielding a dot.
Warning:
-Motors in laser welder are very inconsistent, and sometimes the Inkscape document does not look like the actual welded pattern.
-Needs further investigation.
Important Check List:
- Do the patterns consistently work?
- Do your patterns match up in welder?
- Do your patterns line up consistently?