No edit summary |
|||
Line 26: | Line 26: | ||
== Technical Specifications and Assembly Instructions== | == Technical Specifications and Assembly Instructions== | ||
Orient STL in slicing software as seen below: | |||
[[Image:Pushsticksupports.jpg|200px]] | [[Image:Pushsticksupports.jpg|200px]] | ||
If printer does not have vertical space required then orient like this: | If printer does not have vertical space required then orient like this: | ||
[[Image:Pushsticksupportsside.JPG|200px]] | [[Image:Pushsticksupportsside.JPG|200px]] | ||
Push stick in use can be found below: | |||
[[Image:Pushstickinuse.jpg|200px]] | |||
=== Common Problems and Solutions=== | === Common Problems and Solutions=== |
Revision as of 16:50, 3 December 2019
Table Saw Fence Push Stick
Project developed by User:JasonBell
Template:Statusboxtop Template:Status-design Template:Status-prototype You can help Appropedia by contributing to the next step in this OSAT's status. Template:Boxbottom
Abstract
This part solves the problem of making very thin cuts on a table saw in a safe way. All current push sticks or push blocks on the market do not allow for cuts under 1/2" while still maintaining the guards over the saw blade. This push stick rides on the fence of the saw and allows for a safer cut and makes smaller cuts possible without ruining the user's push stick.
Bill of Materials
This part can be fully printed and no other components are necessary.
Click Here for STL and Source Code
Tools needed for fabrication of the OSAT
- MOST Delta RepRap or similar RepRap 3-D printer
Skills and Knowledge Necessary to Make the OSAT
Product is to be used on a table saw. Safe operation and knowledge of table saw needed for proper use.
Technical Specifications and Assembly Instructions
Orient STL in slicing software as seen below:
If printer does not have vertical space required then orient like this:
Push stick in use can be found below:
Common Problems and Solutions
- Include common mistakes/problems to avoid in building your OSAT and how to overcome them
Cost savings
- If your solution is not a low cost one then it is not really appropriate.
- Estimate your costs
- Find a commercial equivalent, cite it and put the [url in square brackets]
- Calculate $ savings and % savings
Benefited Internet Communities
- Name and add links to at least 5 using single brackets around [url name]
References
- The sources of information (e.g. engineering handbooks, journal articles, government documents, webpages, books, magazine articles etc.). References should use the <ref> </ref> and <references/> tags and can be in any format but should include all the information necessary for someone else to find the same information you did. For example: [1]
- ↑ web page: Department of Energy (DOE) Landscaping and Energy Efficiency, DOE/GO-10095 (1995) Available: http://www.eren.doe.gov/erec/factsheets/landscape.html
Based on the developmental needs addressed (e.g. food, heat, electricity, clean water, health care, etc.) be sure to label your device in the proper categories e.g. use [[Category:Water]]. Be sure to categorize your device so that it will be easy to find – for example “Low voltage connection basics” is categorized in [[Category:How tos]] [[Category:Electricity]] [[Category:Electric lighting]].