(→Safety) |
|||
Line 9: | Line 9: | ||
==Introduction== | ==Introduction== | ||
This page outlines the process of mixing granulated recycled polypropylene with soda-lime recycled glass powder using a metal pan on a hot plate. This process results in a composite of glass particles in a polypropylene matrix. Melting of the plastic is required for an even mixture due to the large difference in particle size between the plastic (d~ 1-3mm) and glass (d < 100 micron). | |||
==Safety== | ==Safety== |
Revision as of 14:44, 29 August 2019
Introduction
This page outlines the process of mixing granulated recycled polypropylene with soda-lime recycled glass powder using a metal pan on a hot plate. This process results in a composite of glass particles in a polypropylene matrix. Melting of the plastic is required for an even mixture due to the large difference in particle size between the plastic (d~ 1-3mm) and glass (d < 100 micron).
Safety
- safety glasses
- wear long pants (natural fibers recommended but not required)
- wear heat-resistant gloves when adding material to pan or mixing
- some gloves still conduct heat through them, so it is better to use a handheld grip such as plyers to hold the pan with the hand not used for mixing.
- turn on fume hood and use N95 dust mask when measuring/adding/mixing glass powder
Equipment or Bill of Materials
- safety glasses
- Thermolyne hot plate
- metal knife/spatula
- 150x75 mm pyrex glass container
- watchglass (6 in. diameter)
- heat resistant work gloves
- dust mask (when using glass)
- K-type thermocouple & reader
- polypropylene granulated from wood chipper
- glass powder
- timer of some sort
Calibration & Tolerances
Operation & Procedure
- turn on hot plate to 5 for heat setting.
- place glass container on hot plate with thermocouple touching bottom of container and watchglass on top, facing downward as lid.
- when thermocouple reads 160 deg Celsius, add polypropylene (PP) and glass powder
- if the PP and glass are added at the same time and heated together, an oxidation reaction will likely occur
- for record-keeping purposes, time how long it takes to melt the plastic/composite.
Shutdown
- trun off hot plate and let it cool down
- also allow composite to cool down after use