Get our free book (in Spanish or English) on rainwater now - To Catch the Rain.

Difference between revisions of "Open Source Bike Brake"

From Appropedia
Jump to navigation Jump to search
 
Line 17: Line 17:
 
# 1 3mmX20mm bolt
 
# 1 3mmX20mm bolt
 
# 1 3mm nut
 
# 1 3mm nut
 +
# Scrap rubber for pad material
 
# Part Files [https://www.youmagine.com/designs/bicycle-brakes]
 
# Part Files [https://www.youmagine.com/designs/bicycle-brakes]
  

Latest revision as of 16:15, 8 December 2019

MOST Delta filament as guide.JPG This page was part of an MTU course MSE4777 OA and MSE4777 OB/MSE5777/EE4777/EE5777: Open-source 3-D printing

Please leave comments using the discussion tab. The course runs in the Fall semester. It is not open edit.


Project Title[edit]

Project developed by [Blake Hereau]
Status
This OSAT has been designed but not yet tested - use at own risk.

You can help Appropedia by contributing to the next step in this OSAT's status.

Abstract[edit]

  1. This project is an attempt to create a simple bicycle brake for the open source community. This brake relies on minimal hardware and uses scarp rubber for the brake pad material. If the users budget allows, conventional bike brake pads could be utilized. These brakes are adjustable to fit a multitude of bikes as long as they have a provision for brakes on the forks of the frame. These brakes are also lighter than conventional materials. Further improvement to this project could be made by making the parts parametric to be easily customized for any bike.
Behereau-full.jpg

Bill of Materials[edit]

  1. 2 7mmx40mm bolts
  2. 2 7mm nuts
  3. 1 3mmX20mm bolt
  4. 1 3mm nut
  5. Scrap rubber for pad material
  6. Part Files [1]

Tools needed for fabrication of the OSAT[edit]

  1. MOST Delta RepRap or similar RepRap 3-D printer
  2. Pliers or tool to remove supports
  3. Basic Bike Maintenance tools

Skills and Knowledge Necessary to Make the OSAT[edit]

Technical Specifications and Assembly Instructions[edit]

  1. After Printing, remove supports from parts.
    Behereau-left-right.jpg
  2. Assemble brake pads by running a bolt through and seating it in the hole.
    Behereau-pads.jpg
  3. Run the scrap rubber across the front through the slots
  4. (Optional Step) Secure rubber to the back of the brake pad with screws
  5. Attach the brake pads to each of the sides with nuts
  6. Mount the brakes on a bike with the center bolt
    Behereau-full.jpg
  7. Run the brake cable through the top and attach it to the
Print Time - Approximately 3 hours
Assembly time - 20 minutes



Common Problems and Solutions[edit]

Supports can be tricky to remove. Try reducing the amount of supports to make it easier to break them free.

Cost savings[edit]

Print cost $1
Hardware cost $3
Total $4
Commercial equivalent $18 - [2]
Cost Saving
$14 cheaper
77% cheaper
Potential for more savings by reusing parts from old brakes or fasteners on hand.

Benefited Internet Communities[edit]

Bike Forums [3] Cycle Chat [4] Bike Radar [5]

References[edit]

<nowiki>