Franklin Firmware on GigabotHX:MOST: Difference between revisions

Revision as of 02:08, 9 May 2016

This page is dedicated to describing the proper operational procedures for successful prints on the Gigabot utilizing Franklin firmware.

Currently, the following pages exists in dedication to either Franklin and/or the GigabotHX:

Application and material development pages are available in the following:

Further Franklin discussion can be found on MOST publication:

Wijnen, B., Anzalone, G. C., Haselhuhn, A.S., Sanders, P.G., Pearce, J. M. Free and Open-source Control Software for 3-D Motion and Processing. Journal of Open Research Software, 4: e2, DOI: http://dx.doi.org/10.5334/jors.78 free access

@@ Line 3: / Line 3: @@
 ==Introduction==
-This page is dedicated to describing the proper operational procedures for successful prints on the Gigabot utilizing Franklin firmware. Currently, the following pages exists in dedication to either Franklin and/or the GigabotHX.
+This page is dedicated to describing the proper operational procedures for successful prints on the Gigabot utilizing Franklin firmware.
+Currently, the following pages exists in dedication to either Franklin and/or the GigabotHX:
 * [[Franklin]]
 * [[Franklin:MOST]]
 * [[GigabotHX]]
+Application and material development pages are available in the following:
+* [[MOST Delta end effector for polypropylene]]
+* [[Metal wire embedding in fused filament 3-D printing]]
+Further [[Franklin]] discussion can be found on [[MOST]] publication:
+* Wijnen, B., Anzalone, G. C., Haselhuhn, A.S., Sanders, P.G., Pearce, J. M. Free and Open-source Control Software for 3-D Motion and Processing. ''Journal of Open Research Software'', 4: e2, DOI: http://dx.doi.org/10.5334/jors.78 [https://www.academia.edu/20974474/Free_and_Open-source_Control_Software_for_3-D_Motion_and_Processing free access]
 ==Procedures==