The Cup Holder is a 3D printed handle designed to hold disposable cups containing hot liquids. It takes the form of a ring-shaped band sized to fit around a disposable cup, with an integrated loop handle on one side, allowing the user to grip and carry the cup without direct hand contact with the hot cup surface. As a reusable, durable alternative to disposable cardboard cup sleeves, which are typically used once and discarded, it can help reduce single-use waste generated from hot beverage service.
The holder is 3D printed using ABS plastic filament, with a total production time of approximately 95 minutes.
Open the file using slicing software and prepare for 3D printing. Use the printing settings below.
Setting
Value
Layer Height
0.2 mm
Quality
Normal
Infill Density
65%
Infill Pattern
Cubic
Support
Yes
Raft
Yes
Production Time
~95 minutes
About the manuals
Field Ready develops manuals to support both the fabrication and safe use of its products. A maker manual provides step-by-step instructions for replicating the design, including materials, tools, and assembly guidance, so that makers in different locations can build the product accurately and consistently. A user manual, where applicable, explains how to properly set up, use, and maintain the product once it is built, helping ensure it performs safely and as intended for the end user. Together, these manuals make the design accessible to both fabricators and the people who ultimately rely on the product.
