Line 27: | Line 27: | ||
== Technical Specifications and Assembly Instructions== | == Technical Specifications and Assembly Instructions== | ||
# | |||
# the Print takes roughly 1 hour and 30 min | '''Instructions''' | ||
# Line the two parts up as shown in the image below, the flat edge facing down. | |||
#Insert the Stake Prong inside the Stake base and line up the holes. | |||
#insert screw | |||
* the Print takes roughly 1 hour and 30 min | |||
* The stake can be assembled in less than 1 minute | |||
* Including drawings or pictures of the device at stage of assembly at minimum. (http://www.appropedia.org/Special:Upload) | |||
Revision as of 03:29, 6 December 2016
Semi-Permanent Stake
Project developed by [Jakerob http://www.appropedia.org/User:Jakerob]
Template:Statusboxtop Template:Status-design Template:Status-prototype You can help Appropedia by contributing to the next step in this OSAT's status. Template:Boxbottom
Abstract
- This Stake has been designed to serve as a semi-permanent connection between earth and man made shelter. current stakes work well but do not take much to kick out of the ground. this can be annoying and dangerous. My design creates an inexpensive alternative to classic stakes. My design creates a better hold and can be made in less than two hours!
Bill of Materials
- Provide a full BOM -- Materials needed for fabrication of device and alternative materials if they are not available, prices/sources of non-printable parts
- Upload and link to all source files from open source CAD
- Upload and link to all STLs
Tools needed for fabrication of the OSAT
- MOST Delta RepRap or similar RepRap 3-D printer
- A screwdriver/ Drill
Technical Specifications and Assembly Instructions
Instructions
- Line the two parts up as shown in the image below, the flat edge facing down.
- Insert the Stake Prong inside the Stake base and line up the holes.
- insert screw
- the Print takes roughly 1 hour and 30 min
- The stake can be assembled in less than 1 minute
- Including drawings or pictures of the device at stage of assembly at minimum. (http://www.appropedia.org/Special:Upload)
Common Problems and Solutions
- The holes on the stake body may need to be altered if using different sized screws
Cost savings
- Cost per Stake: $0.94
- The closest item on the market is the spiral locking stake which is roughly $1.50
- Cost savings 37%