Parts List
Part | Description | Count |
---|---|---|
Drive gear located on motor shaft. Inserted with a 3mm hex nut and bolt on side mount to tighten unit to the shaft. | 2 | |
Driven Gear located on axle assembly. Attached to wheel via 3mm hex nuts and bolts, compressed together within axle assembly. | 4 | |
Wheel located on the end of the axle assembly. Joins to the 72-tooth gear and is base for tire to mount onto. | 4 | |
NinjaFlex Tire with custom treads. Mounts onto wheel by sliding over ridges and held in place via friction. | 4 | |
Bearing Carrier for the entire axle assembly and is bolted directly into the aluminium extrusion via t-nuts. | 4 | |
Motor mount located on either side of GrowBot. Base for encoder mounts and support torque driven through the chassis. | 2 | |
Encoder Mounts on the end of both motors. Mount directly to the the motor mounts via 3mm bolts and heat inserted nuts. | 2 | |
E-Stop mount for easy access to disable robot movement in case of an emergency. | 1 | |
Rack and Pinion carrier for water sensor located on the outside of the Growbot. | 1 | |
Standoffs located on rear section of motor mounts to aid in connection to chassis. | 4 | |
Battery carrier that sits inside GrowBot chassis, bolts up directly to bottom plate. | 1 |