Create the page "Pololu stepper controller" on this wiki! See also the search results found.
- point for an NES controller. Human control was a specification for the design, and NES controllers are rather simplistic, so an NES controller was chosen as4 KB (563 words) - 18:17, 18 June 2024
- degree bipolar stepper motors Mechanical limit switches (end stops) RAMPS 1.3 board Arduino MEGA rev. 0 Pololu Stepper motor controllers (4) Improved Printable4 KB (544 words) - 15:35, 9 June 2023
- ion_System http://reprap.org/wiki/Stepper_motor http://reprap.org/wiki/Stepper_motor http://reprap.org/wiki/Stepper_motor http://en.wikipedia.org/wiki50 KB (6,322 words) - 07:09, 28 June 2024
- replacement of printer controller and power supply. The beaglebone and melzi controller are replaced with an arduino mega compatible micro controller with RAMPS 16 KB (656 words) - 19:07, 18 June 2024
- Vin/Vusb bridge Supply 12VDC (or 7.4VDC battery) to the 5VDC and 3.3VDC step-down convertors. Note the power supply, convertors, and PCBs have a shared21 KB (1,546 words) - 22:22, 18 June 2024
- (Samtec) 40 pin raspberry pi header $1(Pololu robotics) MP6500 stepper motor controller board, 3 x $6 = $18, from Pololu Robotics 12 Volt barrel connectors11 KB (1,777 words) - 18:57, 18 June 2024
- ottobre 2015. BMO aperto di Hangprinter versione 3 (con Mechaduino come controller motore a circuito chiuso) !!OBBLIGATORIO!! Mantenere le rotazioni piccole51 KB (1,140 words) - 19:53, 29 December 2023
- already has five nop operations in the middle of the stepping code (see the workhorse function in stepper.cpp), that could be utilized for IMU readings at13 KB (997 words) - 17:48, 18 June 2024
