Parts Needed

In order to create this holder you will need to print off the following parts The fill of the parts can be fairly low (10%-15%)

• 1-Base
• 2-Movable parts
• 4-pins
• 4 bushings

tools needed

• most delta 3_d printer or similar model
• PLA filiment

Part Assembly

To Begin

1. place the pins into all of the bushings like figure 1 shows
2. next place the pin bushing assembly into the moving part as figure 2 shows, depending on your filament the pin may need to be moved into a different spot.
3. If desired, screw the base to desired location using the tabs on the side of the base. This is not necessary.
4. Place the movable part assembly into the base

• 
  step 1
• 
  step 2
• 
  step 4
• 
  completed spool holder