{"id":58796,"key":"Fully_adjustable,_fully_printable_spool_holder","title":"Fully adjustable, fully printable spool holder","latest":{"id":1206271,"timestamp":"2025-11-27T19:50:03Z"},"content_model":"wikitext","license":{"url":"https://www.appropedia.org/Appropedia:Copyrights","title":"CC-BY-SA-4.0"},"source":"[[File:Fullassembl.JPG|thumb]]\n\n{{777 notice}}\n\n== Fully adjustable, fully printable filament spool holder ==\n\nThis is a fully adjustable, fully printable spool holder, just as the title says. There is also an option for a tool tray to go along with the spool holder, this part can be found at the same location as the rest.\n\n== Instructions ==\n\nThese parts can be found at [http://www.thingiverse.com/thing:575388 thingiverse]\n\n==== Parts Needed ====\n\nIn order to create this holder you will need to print off the following parts\nThe fill of the parts can be fairly low (10%-15%)\n\n* 1-Base\n* 2-Movable parts\n* 4-pins\n* 4 bushings\n\n==== tools needed ====\n\n* most delta 3_d printer or similar model\n* PLA filiment\n\n==== Part Assembly ====\n\nTo Begin\n\n# place the pins into all of the bushings like figure 1 shows\n# next place the pin bushing assembly into the moving part as figure 2 shows, depending on your filament the pin may need to be moved into a different spot.\n# If desired, screw the base to desired location using the tabs on the side of the base. This is not necessary.\n# Place the movable part assembly into the base\n\n<gallery>\nFile:Pin bushing.JPG|step 1\nFile:Pinassem.JPG|step 2\nFile:Fullassembl.JPG|step 4\nFile:Spool holder.JPG|completed spool holder\n</gallery>\n\n{{Page data\n| license = CC-BY-SA-3.0\n}}"}