No edit summary |
No edit summary |
||
Line 4: | Line 4: | ||
==Software Method== | ==Software Method== | ||
:This is a very simple method with which you only have to change software settings in Cura Lulzbot. | |||
#. Change the print setup to custom. | |||
#. Find "Material" Settings. | |||
#. Change the "Diameter" to 1.75 as shown in the picture |
Revision as of 19:44, 5 September 2019
Printing 1.75 mm filaments using 3 mm printers such as Lulzbot TAZ 6 and Lulzbot mini
- You can print with 1.75 mm filaments using printers which use 3 mm filaments by default.
- The page will describe the methods by just using software and both software and hardware to get even more better results.
Software Method
- This is a very simple method with which you only have to change software settings in Cura Lulzbot.
- . Change the print setup to custom.
- . Find "Material" Settings.
- . Change the "Diameter" to 1.75 as shown in the picture