OSHE High Temperature 3D Printer

Revision as of 11:36, 14 December 2018 by Alwoern (Talk | Contributions) (References)

Revision as of 11:36, 14 December 2018 by Alwoern (Talk | Contributions) (References)

OSHE HT Printer.jpg

High Temperature 3D Printer for Open Source Hardware Enterprise

Senior Design project developed by Aubrey Woern and Daniel Scsavnicki
Status
This OSAT has been designed but not yet tested - use at own risk.
This OSAT has been prototyped.

You can help Appropedia by contributing to the next step in this OSAT's status.

Abstract

Bill of Materials

Tools needed for fabrication of the OSAT

  1. MOST Delta RepRap or similar RepRap 3-D printer
  2. Allen Wrench (For M5 and M3 Bolts)
  3. Soldering Iron and Solder

Skills and Knowledge Necessary to Make the OSAT

Technical Specifications and Assembly Instructions

Common Problems and Solutions

Cost savings

Case Study Prints

References