The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then publish the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 31: | Line 31: | ||
*Do NOT adjust the base screws. Only adjust the bigger screw that controls the z-axis with slight movements. | *Do NOT adjust the base screws. Only adjust the bigger screw that controls the z-axis with slight movements. | ||
*Thermistor connection gets messed up and the printer stops extruding because the temp is too low. '''FIXED''' [[User:Ejhunt|Emily Hunt]] ([[User talk:Ejhunt|talk]]) 07:31, 18 February 2014 (PST) | *Thermistor connection gets messed up and the printer stops extruding because the temp is too low. '''FIXED''' [[User:Ejhunt|Emily Hunt]] ([[User talk:Ejhunt|talk]]) 07:31, 18 February 2014 (PST) | ||
*Prints fine then keeps disconnecting for no apparent reason. '''FIXED''' [[User:Ejhunt|Emily Hunt]] ([[User talk:Ejhunt|talk]]) 10:40, | *Prints fine then keeps disconnecting for no apparent reason. '''FIXED''' [[User:Ejhunt|Emily Hunt]] ([[User talk:Ejhunt|talk]]) 10:40, 18 February 2014 (PST) | ||
{{Page data}} | {{Page data}} | ||
[[Category:MOST methods]] | [[Category:MOST methods]] |