(Undo revision 376203 by J.M.Pearce (talk)) |
m (Reverted edits by Dove (talk) to last revision by J.M.Pearce) |
||
Line 1: | Line 1: | ||
{{MOST}} | {{MOST}} | ||
=Mount Extruder= | |||
{{MOST RepRap Ed}} | {{MOST RepRap Ed}} | ||
# Pass the x-carriage between the threaded rods at the top of the printer. | # Pass the x-carriage between the threaded rods at the top of the printer. | ||
# Press the x-carriage onto the LM8UU bearings on the x-axis. Use your fingers and thumb like a clamp, pressing the LM8UU bearings into the carriage. Considerable force is required. DO NOT press down on the carriage without supporting the x-axis guide rods from below - something important will break, causing sadness, anger and/or frustration. | # Press the x-carriage onto the LM8UU bearings on the x-axis. Use your fingers and thumb like a clamp, pressing the LM8UU bearings into the carriage. Considerable force is required. DO NOT press down on the carriage without supporting the x-axis guide rods from below - something important will break, causing sadness, anger and/or frustration. | ||
# Slide the extruder drive mount onto the top threaded rods of the frame. Secure it with M8 washers and nuts. | # Slide the extruder drive mount onto the top threaded rods of the frame. Secure it with M8 washers and nuts. |
Revision as of 02:25, 28 November 2018
Mount Extruder
- Pass the x-carriage between the threaded rods at the top of the printer.
- Press the x-carriage onto the LM8UU bearings on the x-axis. Use your fingers and thumb like a clamp, pressing the LM8UU bearings into the carriage. Considerable force is required. DO NOT press down on the carriage without supporting the x-axis guide rods from below - something important will break, causing sadness, anger and/or frustration.
- Slide the extruder drive mount onto the top threaded rods of the frame. Secure it with M8 washers and nuts.