Table Saw Fence Push Stick

Project developed by User:JasonBell

Abstract

This part solves the problem of making very thin cuts on a table saw in a safe way. All current push sticks or push blocks on the market do not allow for cuts under 1/2" while still maintaining the guards over the saw blade. This push stick rides on the fence of the saw and allows for a safer cut and makes smaller cuts possible without ruining the user's push stick.

Bill of Materials

This part can be fully printed and no other components are necessary.

Click Here for STL and Source Code

Tools needed

1. MOST Delta RepRap or similar RepRap 3-D printer

Skills and knowledge needed

Product is to be used on a table saw. Safe operation and knowledge of table saw needed for proper use.

Technical Specifications and Assembly Instructions

Orient STL in slicing software as seen below (supports shown):

If printer does not have vertical space required then orient like this(supports shown):

Push stick in use can be found below:

Cost savings

Estimated Cost in PLA: $1.40

Commercial Equivalent: No standard equipment performs this specific task in this way. The closest representation is a generic push stick found here

Cheapest Commercial equivalent with less functionality for $10.19

3D Printed for $1.40

Cost Savings ~ $8.79 +

% Cost Savings ~ 86% Savings +

Benefited Internet Communities

Woodworking Talk

Lumberjocks

The Woodworking Patriot

Woodtalk

Way of Wood

References

Woodworking Catalogs

Wood Working Tool Designs

Woodworking Tools List