▼This page was part of an MTU course MSE4777 OA and MSE4777 OB/MSE5777/EE4777/EE5777: Open-source 3-D printing

Please leave comments using the talk page. The course runs in the Fall semester. It is not open edit.

Handlebar grip for a bicycle developed by Abhijeet Divekar

This part was built to meet the needs of one of our professors; Dr. Greshenson, that heads a bike Enterprise program at Michigan Tech.

Bill of Materials

1. No additional materials needed. Open source softwares, computer and RepRap is all you need.
   1. SCAD
   2. STL

Tools needed

1. MOST Delta RepRap or similar RepRap 3-D printer
2. OpenSCAD
3. Slicing Software, like Cura or Slic3r

Skills and knowledge needed

• No special skill(s) needed.

Technical Specifications and Assembly Instructions

No special instructions needed. Pretty straight-forward.

Cost savings

• If your solution is not a low cost one then it is not really appropriate.

Typical handlebar grip costs anywhere between $3 - $8 Amazon. The 3D printed equivalent costs about 60 cents for a pair. So the cost basically reduced about 10 times the commercial equivalent.

References

• Dr. Greshenson's Lab for measurements.