▼This page was part of an MTU course MSE4777 OA and MSE4777 OB/MSE5777/EE4777/EE5777: Open-source 3-D printing

Please leave comments using the talk page. The course runs in the Fall semester. It is not open edit.

As a member of Superior Search and Rescue, I find myself using a GPS frequently during training exercises or actual searches. At times, it can be inconvenient to continuosly remove my GPS from a pocket or backpack in order to navigate. This GPS clip is an attempt to alleviate that issue by allowing a user to mount a GPS to a belt, backpack strap, or other webbing attachment.

Bill of Materials

• BOM - https://www.youmagine.com/designs/garmin-gps-clip

1. 1. 1.75mm Filament
   2. 2-Part Plastic Epoxy

Tools needed

1. MOST Delta RepRap or similar RepRap 3-D printer

Skills and knowledge needed

• 3D printer and slicing software for the provided STL's

Technical Specifications and Assembly Instructions

1. Both the mount and clip will printed in under a half an hour
2. Both files should be printed at 0.2 mm layer height with a 30% infill.