Download these pages as a PDF so you can print them or read them offline.
Booklet
Download these pages as a PDF that you can print, fold and staple into a booklet.
Constructing the Lower Platform
Before You Begin
Make sure you have the everything to build the lower platform:
Hardware:
3 – M3x35mm socket head screws
3 – M3 ny-lock nuts
6 – M3 Flat Washers
Printed Parts:
3 – Motor Ends
3 – Platform Spacers
Required Tools:
2.5mm Alan Wrench
5.5mm Combination wrench
Recommended Tools:
3mm or 1/8” Drill bit
Building the lower platform
Take 1 M3 x 35mm and put 1 washer on it. Insert it into one of the two holes opposite the motor mount.Step One
Slide the screw through the hole in the platform spacer. make sure the flat part is down.
Place another motor end on the screw after the platform spacer, followed by 1 washer and 1 ny-lock nut. Do not tighten the nut all the way, keep the nut loose, in order to attach the other two platform spacers. Repeat steps 1-3 for the rest of the motor mounts and spacers. Once complete, tighten all the screws and nuts.Steps 2 & 3Steps 2 & 3
