▼This page was part of an MTU course MSE4777 OA and MSE4777 OB/MSE5777/EE4777/EE5777: Open-source 3-D printing

Please leave comments using the talk page. The course runs in the Fall semester. It is not open edit.

This OSAT is a heavy-duty rope pulley that can be used to raise water from a well.^[1] This pulley can be customized to any desired size, and can be paired with multiples of itself to further increase mechanical advantage.

Device resources

Manufacturing files

https://www.thingiverse.com/thing:571542

Hardware license

CERN-OHL-S

Certifications

Start OSHWA certification

Bill of Materials

• The wheel and mount are designed to be printed in PLA or ABS, and the parts are customizable to any desired metric bolt size from M4 to M10.
• The parts can be customized here: http://www.thingiverse.com/thing:571542, and source files are also found here: http://libre3d.com/category/569/Hand-Tools/listings/801/OSAT-Pulley.html
• Total BOM: Printed mount, printed pulley wheel, 1 bolt for the shaft, 1 nut.

Tools needed

• MOST Delta RepRap or similar RepRap 3-D printer

Skills and knowledge needed

• Ability to operate a 3D printer and Thingiverse Customizer.

Technical Specifications and Assembly Instructions

• Assembly instructions with images can be found here: http://imgur.com/a/5Ilmk
• Print time estimate: ~4 hours, depending on the parameters entered.
• Assembly time estimate: 2 minutes

Cost savings

• Fully customizable size: Priceless
• OSAT Total Cost: Printed parts ($1.86) + hardware($0.74) = $2.60
• Closest commercial equivalent: http://goo.gl/ClkS1T
• $8.90 savings and 77.4% savings

References