▼This page was part of an MTU course MSE4777 OA and MSE4777 OB/MSE5777/EE4777/EE5777: Open-source 3-D printing

Please leave comments using the talk page. The course runs in the Fall semester. It is not open edit.

The mineral sifter is an excellent example of OSAT. Sifters are a major time saver, especially in third world countries where simple appliances are difficult to come by. This sifter can be used in a variety of different ways ranging from cooking to gardening.

Bill of Materials

1. PLA or any other available 3D printable plastic
2. The link to download this design can be found here

Tools needed

1. MOST Delta RepRap or similar RepRap 3-D printer

Skills and knowledge needed

• No special skills were used to produce this sifter, other than basic 3D printing knowledge.

Technical Specifications and Assembly Instructions

1. My print was made by extruding the PLA at 205C. The print was made using a 20% hexagonal infill, the infill pattern had very little affect on the overall rigidity of the final piece, and be used for the application. There is no assembly process, as the design is one simple printed part.
2. The print time on a delta printer was around 4 hours, using 70g of filament.
3. There is no necessary assembly involved in the finished product.

Cost savings

1. The total cost to print this design is around $2.00
2. Commercial equivalent, $18.85
3. 89.4% Savings

Benefited Internet Communities

• DIY
• OSHE:
• OSAT:
• Bakers:
• Gardeners:
• YouImagine
• Thingiverse