▼This page was part of an MTU course MSE4777 OA and MSE4777 OB/MSE5777/EE4777/EE5777: Open-source 3-D printing

Please leave comments using the talk page. The course runs in the Fall semester. It is not open edit.

This device is used to collect a small fecal sample for testing. This can range from DNA testing to testing for disease. Fecal matter can tell a lot about someones genetics and body function. This device is appropriate for OSAT because it can be used in developing countries and palces like Africa for testing for diseases. [Note to creator: Africa is a continent containing many countries with varying levels of development. Be careful when generalizing.] The device that has been developed is similar to the design shown below, but costing nearly 99% when compared. It was developed for Kijenzi/ HESE.

A similar design can be seen here.

Bill of Materials

1. PLA or similar Printable material is all that is needed. PLA would be most appropriate due to its environmentally friendly nature
   1. All of my STL and SCAD files can be found at the following link: https://www.youmagine.com/designs/fecal-sample-kit

Tools needed

1. MOST Delta RepRap or similar RepRap 3-D printer

Skills and knowledge needed

• There were no "special" skills or knowledge used to create this device. The only tool i used was the OpenScad cheat sheet for reference on some functions

Technical Specifications and Assembly Instructions

1. To assemble this project, it is fairly simple. Once it is printed, it should just screw together with the printed threads. I did use 2 sets of pliers to get the threads to loosen up a bit do to the variance in my printer. To print this project, make sure to rotate the base.stl 180 degrees so that the bottom is on the build plate, as i designed it upside down.
2. Print Time: 1.5 hours
3. Assembly Time: 10 seconds
4. The images shown show the 2 printed parts and what they look like when assembled.

Cost savings

1. The cost to make this part is only $0.24 when using a $20 1 kg roll of PLA. It only uses 12 g of material.
2. A commercial equvilent can be found here. It costs $131

for 500 so 26 cents each

Benefited Internet Communities

• Kinjezi/HESE @ Penn state
• Concern Project
• Bill and Linda Gates Foundation
• The Red Cross
• US Agency for International Development

References

• https://www.thingiverse.com/thing:19240