{"id":64698,"key":"Screw_driver","title":"Screw driver","latest":{"id":1032175,"timestamp":"2023-10-23T12:39:02Z"},"content_model":"wikitext","license":{"url":"https://www.appropedia.org/Appropedia:Copyrights","title":"CC-BY-SA-4.0"},"source":"{{777 notice}}\n\n{{Project data\n| authors = User:Brhutchi\n| made = No\n| replicated = No\n}}\n\n== Screw Driver ==\n\nComponents\n[https://www.appropedia.org/File:CAP.stl]\n[https://www.appropedia.org/File:Sfdag.stl]\n\n== Abstract ==\n\n# With this design I always see screw drivers being made, however I wanted a simple design of a screw driver but also allowing me to store bits in the design.\n\n== Bill of Materials ==\n\n## RepRap 3D printer ($500)\n## PLA filament (1 spool - $25)\n## screwdriver bits ($7.97)- http://www.amazon.com/gp/product/B000HLGPFG?keywords=screwdriver%20bits&qid=1447944686&ref_=sr_1_3&sr=8-3\n\n== Tools needed ==\n\n# [[Athena Build Overview|MOST Delta RepRap]] or similar RepRap 3-D printer\n# Elmers Glue Stick\n\n== Skills and knowledge needed ==\n\n* No special skills required\n\n== Technical Specifications and Assembly Instructions ==\n\n# Provide directions for print/assembly - be detailed enough in your “how to” to ensure that someone could construct the device from your description. Consider the elegance of IKEA like instructions.\n# time estimate 2 HOURS\n# 5 minutes\n\n=== Common Problems and Solutions ===\n\n* some problems are the hole for the end bit\n* and cap correctly fitting\n\n== Cost savings ==\n\n* If your solution is not a low cost one then it is not really appropriate.\n# 48grams = $1.20\n# $15.07 commercial equivalent - Screwdriver Sets: Klein Toolss 5-Piece Magnetic Screwdriver Set 70035\n# 15.07-1.20=13.87\n\n{{Page data\n| keywords = 3D printing, hand tools, screw driver, construction\n| sdg = SDG08 Decent work and economic growth, SDG09 Industry innovation and infrastructure\n| license = CC-BY-SA-3.0\n| language = en\n}}\n\n[[Category:OSAT 3D-Printable Designs]]\n[[Category:3D printing]]\n[[Category:Construction]]"}