{"id":28790,"key":"Protocal_for_Testing_Printed_Plastic","title":"Protocal for Testing Printed Plastic","latest":{"id":1205164,"timestamp":"2025-11-27T15:04:21Z"},"content_model":"wikitext","license":{"url":"https://www.appropedia.org/Appropedia:Copyrights","title":"CC-BY-SA-4.0"},"source":"== Protocol for Printing Parts to be Tested ==\n\n1) Level Bed.<br>\n2) Prep extruder by extruding at correct temperature at various RPM.<br>\n3) Start print.<br>\n4) Mark down: time, kwh, temperature of room and humidity of room (do this for the start and ending of the print).<br>\n5) Weight test part with base on.<br>\n6) Remove base gently.<br>\n7) Weigh part without base.<br>\n8) Measure width and length along part at intervals.<br>\n\n{{Page data\n| license = CC-BY-SA-3.0\n}}\n\n[[Category:Queens Applied Sustainability Group Lab Protocols]]"}