{"id":50873,"key":"Motor_force_protocol","title":"Motor force protocol","latest":{"id":1205134,"timestamp":"2025-11-27T15:00:57Z"},"content_model":"wikitext","license":{"url":"https://www.appropedia.org/Appropedia:Copyrights","title":"CC-BY-SA-4.0"},"source":"{{MOST}}\n\n=== Force Testing Protocol ===\n\n==== Using an Instron 4206 Tensile Test Machine with a 10kN Load Cell ====\n\nDOES NOT NEED CALIBRATION\n\n# Set the raspberry pi to max current.\n# Only put the plunger of the syringe in the pump, not the entire syringe.\n# Place the pump, motor down, in a tensile strength tester. Set height of the load cell to be just above the pump.\n# Then tell the pump to push past the top plate.\n# Record the force given in Newtons.\n\n{{Page data\n| license = CC-BY-SA-3.0\n}}\n\n[[Category:MOST methods]]"}