{"id":74690,"key":"Jellybox_improvement_based_on_23._Feedback","title":"Jellybox improvement based on 23. Feedback","latest":{"id":1206736,"timestamp":"2025-11-27T20:44:51Z"},"content_model":"wikitext","license":{"url":"https://www.appropedia.org/Appropedia:Copyrights","title":"CC-BY-SA-4.0"},"source":"{{242 notice}}\n\n# A printer that will constantly monitor and send live updates.\n\n-Camera for live updates\n\n-Messages sent to user- 'print done', 'print failed', etc.\n\n-Before print, check conditions & inform user of probability of success\n\n# A sensor that checks for filament\n** A little laser tripwire would go above the extruder\n** This tripwire would constantly be checking for filament, as long as the laser is tripped, it will know that the printer is still getting filament\n** If the extruder is no longer getting filament, the laser would connect, and this would make the Arduino print a message to the screen saying, \"Low filament, pausing print\" and make a beeping sound to alert the user.\n** To continue the print, insert more filament and hit the \"Resume Print\" button\n\n----\n[[User:Jacob.huss|Jacob Huss]] ([[User talk:Jacob Huss|talk]]) 08:33, 20 April 2018 (PDT)\n[[User:Alan Freeman|Alan Freeman]] ([[User talk:Alan Freeman|talk]]) 08:33, 20 April 2018 (PDT)\n[[User:GabrielFugman|GabrielFugman]] ([[User talk:GabrielFugman|talk]]) 07:15, 20 April 2018 (PDT)\n[[User:Aaron.cranford|Aaron.cranford]] ([[User talk:Aaron.cranford|talk]]) 07:16, 20 April 2018 (PDT)\n\n[[Special:Contributions/155.106.128.121|155.106.128.121]] 07:25, 20 April 2018 (PDT)\n \n[[Ian Armesy's 3D Printing Page]]\n[[User:[[Special:Contributions/155.106.128.121|155.106.128.121]] 07:45, 20 April 2018 (PDT)]]\n\ncamera or 3D sensor apparatus connected to a computer which will monitor the progress of the print. If a tolerance is exceeded during the print the print will be shut down and the user will be notified that it failed\n\n{{Page data\n| license = CC-BY-SA-3.0\n}}\n\n[[Category:242 TRIZ 3D printers]]"}