You do not have permission to edit this page, for the following reason:
You must confirm your email address before editing pages.
Please set and validate your email address through your user preferences.
To edit this page, please answer the question that appears below (more info):
The word 'Appropedia' comes from 'Appropriate' and...?
==Hand Pump Drill (Spring-Loaded)==
Project developed by [Limitless285]
# This Hand Pump Drill is a mechanical drill that utilizes human effort to perform the functions of a drill. In locations where power tools are too expensive or there is little access to electricity, a hand drill is an effective solution. 3D printing these means they can be very cost efficient - less than $0.25 in filament, a spring, and drill bits.
# First Draft [[Image:HandDrill1.PNG|300px|First Draft]]
# First Draft w/ Spring [[Image:Handdrill2.PNG|300px]]
# Final Draft image coming soon!
== Bill of Materials==
# Materials Needed:
## Drill Bit(s) of varying sizes - any standard drill bits should fit this drill.
## (OPTIONAL) Spring to have spring-loaded capabilities: [https://www.mcmaster.com/#9657k439/=178iw9i Purchase here]
## [https://www.thingiverse.com/thing:2291395 STLs and Open-Source (Blender) Source Files Download]
== Tools needed for fabrication of the OSAT==
# Jellybox or similar RepRap 3-D printer
== Technical Specifications and Assembly Instructions==
* This print should take about 4 hours (I printed three different prints - one with 3 pieces, one with 2, and one with 1). These could all be printed in one go, reducing print time drastically.
* Assembly should take no more than 5 to 10 minutes.
# Print all part at .1 mm resolution (lower resolution may still work, but have not been tested)
# All parts should be printed vertically. The end-handle should be printed with the hole on the narrow end facing up.
# Insert spring-slide over the drill body. After a few rotations, it should revolve smoothly.
# Place the chuck-jaws into the drill body with the jaw-cover screwing into the body over the chuck-jaws
## If a spring is being used, place the spring [https://www.mcmaster.com/#9657k439/=178iw9i Spring sized for this print] over the drill body before securing the jaw-cover
# Attach the end handle to the spring-slide
=== Common Problems and Solutions===
* Apply lubricant to the drill body (should not be necessary)
* Ensuring the end-handle is printed with the hole facing up ensures accurate sizing and print quality for a snap-fit.
== Cost savings==
* If your solution is not a low cost one then it is not really appropriate.
# Costs for this hand-drill
* 3D printed drill = $.25
* Drill bit = $1.31 each [https://www.mcmaster.com/#2931a11/=17gho4s Source Link]
* OPTIONAL Spring = $1.40 each [https://www.mcmaster.com/#9657k439/=178iw9i Source Link]
* TOTAL: $ 2.76
# Commercial Equivalent
* $72.50 Spring Loaded Push Drill [http://www.garrettwade.com/garrett-wade-yankee-push-drill-gp.html?scid=W4011000&gclid=CjwKEAjw3KDIBRCz0KvZlJ7k4TgSJABDqOK7gYO2vcjWjWNRMwKlAOlyfDBY7yFAoVMPz4q8u9-lEhoC7_Tw_wcB Source Link]
* $15 for shipping per their calculated shipping policy
* TOTAL: $87.50
# $ savings and % savings
* A total savings of $84.74, or more than 3000% in savings.
[[Category:OSAT 3D-Printable Designs]]