Category:MOST Delta Build
Revision as of 01:28, 19 October 2013 by J.M.Pearce (talk | Contributions)
|
Michigan Tech's Open Sustainability Technology Lab.
Wanted: Students to make a distributed future with solar-powered open-source 3-D printing and recycling. |
|
Pages explaining how to build the MOST Deltabot v1.0 RepRap 3-D Printer.
| Tandem Build MOST Delta Navigation | |
| Green indicate workshop tasks | |
| Printer Primer | |
| Overview | |
| Soldering and tinning | |
| Assembling hot end | |
| Drilling Pilot Holes | |
| Person 1 | Person 2 |
|---|---|
| Tie Rods and Pulleys | Epoxying Magnets |
| Motor End Assembly | Idler End Assembly |
| Extruder Drive | Mount Bases |
| End Effector | Frame |
| Verticals | |
| Wiring | |
| Firmware | |
| Software | |
| Finishing | |
| Printing Basics | |
Fig 1: MOST Delta
Fig 2: MOST Delta side view
Fig 3: MOST Delta top view
Pages in category "MOST Delta Build"
The following 22 pages are in this category, out of 22 total.