Difference between revisions of "Category:MOST Delta Build"
Jump to navigation
Jump to search
m (Created page with "How to build the MOST Delta category:MOST methods") |
m |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | {{MOST}} | |
| + | |||
| + | Pages explaining how to build the MOST Deltabot v1.0 RepRap 3-D Printer. {{template:MOST Delta Nav}} | ||
| + | |||
| + | {{gallery | ||
| + | |width=250 | ||
| + | |height=250 | ||
| + | |lines=1 | ||
| + | |Image:Most-delta.JPG|Fig 1: MOST Delta | ||
| + | |Image:Mtu-delta.JPG|Fig 2: MOST Delta side view | ||
| + | |Image:Topviewmostdelta.JPG|Fig 3: MOST Delta top view | ||
| + | }} | ||
[[category:MOST methods]] | [[category:MOST methods]] | ||
Latest revision as of 15:22, 18 November 2013
|
Michigan Tech's Open Sustainability Technology Lab.
Wanted: Students to make a distributed future with solar-powered open-source 3-D printing and recycling. |
|
Pages explaining how to build the MOST Deltabot v1.0 RepRap 3-D Printer.
| Tandem Build MOST Delta Navigation | |
| Green indicate workshop tasks | |
| Printer Primer | |
| Overview | |
| Soldering and tinning | |
| Assembling hot end | |
| Drilling Pilot Holes | |
| Person 1 | Person 2 |
|---|---|
| Tie Rods and Pulleys | Epoxying Magnets |
| Motor End Assembly | Idler End Assembly |
| Extruder Drive | Mount Bases |
| End Effector | Frame |
| Verticals | |
| Wiring | |
| Firmware | |
| Software | |
| Finishing | |
| Printing Basics | |
Fig 1: MOST Delta
Fig 2: MOST Delta side view
Fig 3: MOST Delta top view
Pages in category "MOST Delta Build"
The following 22 pages are in this category, out of 22 total.