Jump to navigation Jump to search
|Replicated? Was this project made independently by someone other than the authors and without their guidance?|
|Countries of design|
|Estimated cost||USD $ 2.00|
|Sustainable Development Goals|
Gallery[edit | edit source]
Bicycle part: 7up[edit | edit source]
|This Open Source Appropriate Technology has been designed but not yet tested — use at your own risk.|
|This Open Source Appropriate Technology has been prototyped.|
Abstract[edit | edit source]
- The project was offered from Dr. John Gershenson, part of his lab for measurements.
- Picture of completed print
Bill of Materials[edit | edit source]
- Only plastics and 3D-printer needed.
Tools needed for fabrication of the OSAT[edit | edit source]
- MOST Delta RepRap or similar RepRap 3-D printer
Skills and Knowledge Necessary to Make the OSAT[edit | edit source]
- basic measurement
Technical Specifications and Assembly Instructions[edit | edit source]
- Print the top part and down part separately.
- Joint them by heater through the edge of each part.
- printing time for each part is about 1.5 hours.
- Jointing time is about 15 min.
Common Problems and Solutions[edit | edit source]
- Carefully when using the heater, don't burn yourself :)
Cost savings[edit | edit source]
- If your solution is not a low cost one then it is not really appropriate.
- Estimate your costs: about 2 dollar.
- Find a commercial equivalent: about 10 dollar because of the material.
- 8$ savings and 80% savings