Line 37: Line 37:
|height=135
|height=135
|title= [[Printable Parts]]
|title= [[Printable Parts]]
|Image:HolderTop.jpg|Wire Holder Top
|Image:HolderTop.JPG|Wire Holder Top


|width=180
|width=180
|height=135
|height=135
|title= [[Printable Parts]]
|title= [[Printable Parts]]
|Image:HolderBottom.jpg|Wire Holder Bottom
|Image:HolderBottom.JPG|Wire Holder Bottom


}}
}}

Revision as of 21:23, 7 November 2016

Wire Holder Prototype

Team

Nicholas Lanter Undergrad student, Computer Engineering

Logan Brueck Undergrad student, Mechanical Engineering

Project

Test Lead Holder

An open source wire lead holder that can be easily printed for any lab. Saving both time and money.

A commercial off the shelf wire holder would cost about $15, this holder will cost $2.07 to print and mount. It can be printed in just a few hours which would be much faster than if you had to order and ship one.

Prototype

Bill Of Materials

  • 3x #6 sheet metal screws @ $0.372 per screw
  • Approximately 70 grams of PLA or equivalent filament @$0.24 per gram. $1.70

Total Cost ~$2.07

Installation and Use

  • Install using 3x #6 sheet metal screws and slide wire holder over screws, then tighten.

Files

Cookies help us deliver our services. By using our services, you agree to our use of cookies.